Browsing Electrical, Electronic and Computer Engineering by Type "Presentation"

Browsing Electrical, Electronic and Computer Engineering by Type "Presentation"

Sort by: Order: Results:

  • A comparison of basic 94 GHz planar transmission line resonators in commercial BiCMOS back-end-of-line processes 
    Stander, Tinus; International Conference on Actual Problems of Electron Devices Engineering (APEDE), 2014: Saratov (Institute of Electrical and Electronics Engineers, 2014)
    A comparative simulation study of planar 94 GHz resonators in a typical BiCMOS BEOL stack-up is presented, with the effect of chip passivation included. It is shown that Q-factors of between 3 and 15 can be obtained, ...
  • Development, simulation and construction of cost-effective GTEM cells 
    Sinha, Saurabh; Stander, Tinus; International Conference on Radioelektronika, (23rd : 2013 : Pardubice, Czech Republic) (Institute of Electrical and Electronics Engineers, 2013-04)
    Gigahertz transverse electromagnetic (GTEM) cells are used extensively in industry for testing the impact of defined E-fields on devices sensitive to electromagnetic interference. Compared to anechoic chambers, GTEM ...
  • Entrepreneurship as an IEEE workforce development theme 
    Sinha, Saurabh; Stander, Tinus; IEEE Global Humanitarian Technology Conference (GHTC) (2013 : San José, California, United States of America) (Institute of Electrical and Electronics Engineers, 2013)
    The IEEE is currently planning an extensive workforce development (WFD) programme through its volunteer and associated networks. Together with environmental scans, potential learning areas and contributing partners are ...
  • A frequency agile switched delay line slow-wave 
    Sinha, Saurabh; Bhana, V.B. (Vishal); Stander, Tinus; International Conference on Radioelektronika, 23rd : 2013 : Pardubice, Czech Republic (Institute of Electrical and Electronics Engineers, 2013-04)
    A mm-wave BiCMOS back-end metallization switched delay line frequency agile filter is presented. Miniaturization of the delay lines is achieved by using slow-wave propagation modes on shielded CPWs, with a standard ...
  • Inactivating pathogenic micro-organisms through microwave sterilization technology 
    Sinha, Saurabh; Stander, Tinus; Du Preez, Jaco; International Symposium on Electrodynamic and Mechatronic System (SELM) 2013 : Opole-Zawiercie (Institute of Electrical and Electronics Engineers, 2013-05)
    Microwave heating as a means of inactivating pathogenic micro-organisms in commercially produced food products in sterilization and pasteurization processes is discussed in this paper. The physics of a microwave heating ...
  • Inline Ka-band transitional combline / evanescent-mode filter in conventional RF substrate using grounded vias 
    Stander, Tinus; IEEE Africon (2015 : Addis Ababa, Ethiopia) (Institute of Electrical and Electronics Engineers, 2015-09)
    The Ka-band is considered a viable band for future 5G backhaul links. Planar filters in this frequency range have low aspect ratios for substrates thicker than 10 mil, since the required 50 Ω line width becomes comparable ...
  • L-band tapered-ridge SIW-to-CPW transion 
    Smith, James Nathan; Stander, Tinus; International Conference on Actual Problems of Electron Devices Engineering (APEDE) (2014 : Saratov, Russia) (Institute of Electrical and Electronics Engineers, 2014)
    A tapered ridge transition between coplanar waveguide and substrate-integrated waveguide is presented. The taper is implemented through staircase metallization across 10 layers of conventional RF substrate with sidewall ...
  • An on-chip post-production tunable group delay equaliser 
    Osuch, Piotr Jan; Stander, Tinus; International Conference on Actual Problems of Electron Devices Engineering (APEDE) (2014 : Saratov, Russia) (Institute of Electrical and Electronics Engineers, 2014)
    A design method for distributed element on-chip post-production tunable group delay equalising networks is presented. It is shown that a number of adjustable Darlington C-sections can be used to equalise the group delay ...
  • A review of key development areas in low-cost packaging and integration of future E-band mm-wave transceivers 
    Stander, Tinus; IEEE Africon (2015 : Addis Ababa, Ethiopia) (Institute of Electrical and Electronics Engineers, 2015-09)
    With an ever increasing number of broadband applications in sub-Saharan Africa, mm-wave point-to-point networking has the potential to fill a niche in communications network architectures. Widespread adoption of this ...
  • Waveguide power combiner with adjustable amplitude and phase response 
    Stander, Tinus; Sinha, Saurabh; International Conference on Radioelektronika (23rd : 2013 : Pardubice, Czech Republic) (Institute of Electrical and Electronics Engineers, 2013)
    Maximum gain from combining multiple high-power signals is achieved by equalising both the amplitude and phase of the combination. Achieving in-phase and equal amplitude power combining with amplifiers of unequal gain and ...