Please be advised that the site will be down for maintenance on Sunday, September 1, 2024, from 08:00 to 18:00, and again on Monday, September 2, 2024, from 08:00 to 09:00. We apologize for any inconvenience this may cause.
dc.contributor.author | Everts, Marilize![]() |
|
dc.contributor.author | Meyer, Josua P.![]() |
|
dc.date.accessioned | 2017-11-27T07:01:18Z | |
dc.date.issued | 2018-02 | |
dc.description | This work was produced as part of a PhD in the Department of Mechanical and Aeronautical Engineering at the University of Pretoria by the first author, under the supervision of the second author. (http://hdl.handle.net/2263/44245) | en_ZA |
dc.description.abstract | Limited work has been done specifically focussing on the relationship between pressure drop and heat transfer in the transitional flow regime. The purpose of this study was therefore to experimentally investigate and compare the pressure drop and heat transfer characteristics of developing and fully developed flow in smooth horizontal circular tubes in the laminar, transitional, quasi-turbulent and turbulent flow regimes. An experimental set-up was designed, built and validated against data from literature. A smooth circular test section with an inner diameter of 11.5 mm, and maximum length-to-diameter ratio of 872, was used. Pressure drop and heat transfer measurements were taken at Reynolds numbers between 500 and 10,000 at different heat fluxes. Water was used as the test fluid and the Prandtl number ranged between 3 and 7. A total of 317 mass flow rate measurements, 34,553 temperature measurements and 2536 pressure drop measurements were taken. Pressure drop and heat transfer measurements were taken simultaneously and the relationship between pressure drop and heat transfer was investigated. It was found that the Reynolds numbers at which transition started and ended was the same for the pressure drop and heat transfer results. Correlations were developed to determine the relationship between heat transfer and pressure drop, as well as the average Nusselt numbers, in the laminar, transitional, quasi-turbulent and turbulent flow regimes, for both developing and fully developed flow in mixed convection conditions. It was found that the relationship between heat transfer and pressure drop can be used as an additional criterion to distinguish the different flow regimes. | en_ZA |
dc.description.department | Mechanical and Aeronautical Engineering | en_ZA |
dc.description.embargo | 2019-02-20 | |
dc.description.librarian | hj2017 | en_ZA |
dc.description.sponsorship | The NRF, Stellenbosch University/University of Pretoria Solar Hub, CSIR, EEDSM Hub, RDP and NAC. | en_ZA |
dc.description.uri | http://www.elsevier.com/locate/ijhmt | en_ZA |
dc.identifier.citation | Everts, Marilize | Meyer, Josua P. 2018, 'Relationship between pressure drop and heat transfer of developing and fully developed flow in smooth horizontal circular tubes in the laminar, transitional, quasi-turbulent and turbulent flow regimes', International Journal of Heat and Mass Transfer, vol. 117, pp. 1231-1250. | en_ZA |
dc.identifier.issn | 0017-9310 (print) | |
dc.identifier.issn | 1879-2189 (online) | |
dc.identifier.other | 10.1016/j.ijheatmasstransfer.2017.10.072 | |
dc.identifier.uri | http://hdl.handle.net/2263/63355 | |
dc.language.iso | en | en_ZA |
dc.publisher | Elsevier | en_ZA |
dc.rights | © 2017 Elsevier Ltd. All rights reserved. Notice : this is the author’s version of a work that was accepted for publication in International Journal of Heat and Mass Transfer. Changes resulting from the publishing process, such as peer review, editing, corrections, structural formatting, and other quality control mechanisms may not be reflected in this document. A definitive version was subsequently published in International Journal of Heat and Mass Transfer, vol. 117, pp. 1231-1250, 2018. doi : 10.1016/j.ijheatmasstransfer.2017.10.072. | en_ZA |
dc.subject | Mixed convection | en_ZA |
dc.subject | Constant heat flux | en_ZA |
dc.subject | Pressure drop | en_ZA |
dc.subject | Heat transfer | en_ZA |
dc.subject | Quasi-turbulent flow | en_ZA |
dc.subject | Transitional flow | en_ZA |
dc.subject | Developing flow | en_ZA |
dc.subject | Pressure drop measurement | en_ZA |
dc.subject | Mass flow rate measurement | en_ZA |
dc.subject | Heat transfer measurement | en_ZA |
dc.subject | Heat transfer characteristics | en_ZA |
dc.subject | Drops | en_ZA |
dc.subject | Turbulent flow | en_ZA |
dc.subject | Temperature measurement | en_ZA |
dc.subject | Reynolds number | en_ZA |
dc.subject | Prandtl number | en_ZA |
dc.subject | Pipe flow | en_ZA |
dc.subject | Heat flux | en_ZA |
dc.subject | Heat convection | en_ZA |
dc.subject | Flow rate | en_ZA |
dc.title | Relationship between pressure drop and heat transfer of developing and fully developed flow in smooth horizontal circular tubes in the laminar, transitional, quasi-turbulent and turbulent flow regimes | en_ZA |
dc.type | Postprint Article | en_ZA |