The influence of multi-walled carbon nanotubes on single-phase heat transfer and pressure drop characteristics in the transitional flow regime of smooth tubes

Show simple item record

dc.contributor.advisor Meyer, Josua P. en
dc.contributor.advisor McKrell, T.J. en
dc.contributor.postgraduate Grote, Kersten en
dc.date.accessioned 2013-09-06T21:19:16Z
dc.date.available 2013-06-12 en
dc.date.available 2013-09-06T21:19:16Z
dc.date.created 2013-04-15 en
dc.date.issued 2012 en
dc.date.submitted 2013-06-10 en
dc.description Dissertation (MEng)--University of Pretoria, 2012. en
dc.description.abstract There are in general two different types of studies concerning nanofluids. The first one concerns itself with the study of the effective thermal conductivity and the other with the study of convective heat transfer enhancement. The study on convective heat transfer enhancement generally incorporates the study on the thermal conductivity. Not many papers have been written on the convective heat transfer enhancement and even fewer concerning the study on multi-walled carbon nanotubes in the transitional flow regime. In this paper the thermal conductivity and viscosity was determined experimentally in order to study the convective heat transfer enhancement of the nanofluids. Multi-walled carbon nanotubes suspended in distilled water flowing through a straight, horizontal tube was investigated experimentally for a Reynolds number range of a 1 000 - 8 000, which included the transitional flow regime. The tube was made out of copper and has an internal diameter of 5.16 mm. Results on the thermal conductivity and viscosity indicated that they increase with nanoparticle concentration. Convective heat transfer experiments were conducted at a constant heat flux of 13 kW/m2 with 0.33%, 0.75% and 1.0% volume concentrations of multi-walled carbon nanotubes. The nanotubes had an outside diameter of 10 - 20 nm, an inside diameter of 3 - 5 nm and a length of 10 - 30 μm. Temperature and pressure drop measurements were taken from which the heat transfer coefficients and friction factors were determined as a function of Reynolds number. The thermal conductivities and viscosities of the nanofluids were also determined experimentally so that the Reynolds and Nusselt numbers could be determined accurately. It was found that heat transfer was enhanced when comparing the data on a Nusselt number as a function of Reynolds number graph but comparing the results on a heat transfer coefficient as a function of average velocity graph the opposite effect was observed. Performance evaluation of the nanofluids showed that the increase in viscosity was four times the increase in the thermal conductivity which resulted in an inefficient nanofluid. However, a study on the performance evaluation criterion showed that operating nanofluids in the transition and turbulent flow regime due to the energy budget being better than that of the distilled water. en
dc.description.availability unrestricted en
dc.description.department Mechanical and Aeronautical Engineering en
dc.identifier.citation Grote, K 2012, The influence of multi-walled carbon nanotubes on single-phase heat transfer and pressure drop characteristics in the transitional flow regime of smooth tubes, MEng dissertation, University of Pretoria, Pretoria, viewed yymmdd < http://hdl.handle.net/2263/25434 > en
dc.identifier.other E13/4/728/gm en
dc.identifier.upetdurl http://upetd.up.ac.za/thesis/available/etd-06102013-163652/ en
dc.identifier.uri http://hdl.handle.net/2263/25434
dc.language.iso en
dc.publisher University of Pretoria en_ZA
dc.rights © 2012 University of Pretoria. All rights reserved. The copyright in this work vests in the University of Pretoria. No part of this work may be reproduced or transmitted in any form or by any means, without the prior written permission of the University of Pretoria en
dc.subject Multi-walled carbon nanotubes en
dc.subject Convective heat transfer en
dc.subject Transition en
dc.subject Performance evaluation en
dc.subject Nanofluids en
dc.subject UCTD en_US
dc.title The influence of multi-walled carbon nanotubes on single-phase heat transfer and pressure drop characteristics in the transitional flow regime of smooth tubes en
dc.type Dissertation en


Files in this item

This item appears in the following Collection(s)

Show simple item record