- UPSpace Home
- →
- Engineering, Built Environment and Information Technology
- →
- Mechanical and Aeronautical Engineering
- →
- Conferences (International Conference on Heat Transfer, Fluid Mechanics and Thermodynamics)
- →
- 12th International Conference on Heat Transfer, Fluid Mechanics and Thermodynamics 2016
- →
- Recent submissions
JavaScript is disabled for your browser. Some features of this site may not work without it.
12th International Conference on Heat Transfer, Fluid Mechanics and Thermodynamics 2016: Recent submissions
Now showing items 21-40 of 293
-
(HEFAT, 2016)The aim of this paper is to investigate a novel technique to control the flow around a circular cylinder. This technique consists of putting a moving membrane stuck to the cylinder. The commercial software Ansys fluent ...
-
(HEFAT, 2013)IC Engine based tri-generation system are readily available in market today. Although such systems are highly efficient, they are mostly based on petroleum and diesel hence, are less environment friendly. This paper presents ...
-
Effect of temperature on physical properties for binary systems: deep eutectic solvent and alcohols (HEFAT, 2016)Compared with the conventional Ionic Liquids, Deep Eutectic Solvents (DES) are more biodegradable and biocompatible. Moreover, they are easily prepared with high purity at low cost. Because of this, an extensive study of ...
-
(HEFAT, 2016)Present paper investigates the influence of inlet air temperature and relative humidity on performance of a PEM Fuel Cell stack with maximum power of 175 W. In order to control the inlet air temperature, a cooling system ...
-
(HEFAT, 2016)Supercritical Fluid Extraction (SFE) is the process of separating one component (the extractant) from another (the matrix) using supercritical fluids that is CO2 as the extracting solvent. Clay soils have specific properties ...
-
(HEFAT, 2016)Publication on cavity flow natural convection by using nanofluids has increased in recent years. On the other hand, contrary results offered by different researchers, both in experimental and numerical works. In this ...
-
Effect of wall surface roughness on droplet cooling over a rectangular heated plate in an enclosure (HEFAT, 2016)Study of evaporation of single droplet plays a very important role in analyzing the process operations of fuel cooling and spraying systems. This has been a pioneering area of research among chemical and heat transfer ...
-
(HEFAT, 2016)In the reflection of shock waves off a surface von Neumann’s theory assumes compressible and inviscid flow. It also assumes the reflecting surface to be perfectly smooth, nonporous, and adiabatic. It is found to be ...
-
(HEFAT, 2016)The main objective of this experimental work is to investigate the effect of pipe surface roughness on frictional component of gas-liquid two phase pressure drop. The pressure drop measurements are carried out with ...
-
(HEFAT, 2016)How to achieve appropriate operating temperatures in present-day electronic equipment is a matter of fervent discussion in the current technical literature. The highly demanding cooling requirements of these devices are a ...
-
(HEFAT, 2016)A dynamic analysis is performed on a traditional helical fin; but, with fixed fin tip temperature, rather than adiabatic fin tip boundary condition. A time dependent solution is provided. The final version of the solution ...
-
(HEFAT, 2016)Education is the job of Educators. In our case we must make sure that the laws of Nature are well discussed in a correct and precise fashion. The First Law of Thermodynamics deals with Energy. This is rather simple to ...
-
(HEFAT, 2016)This paper deals with the design and the features of the DYNASTY (DYnamics of NAtural circulation for molten SalT internallY heated) facility. DYNASTY is a natural circulation loop aimed at studying the dynamics of natural ...
-
(HEFAT, 2016)The main alternative employed for the reboiler in distillation towers is the thermosiphon. In this case, the flow circulation does not depend on the existence of a pump, the flow is promoted by the difference in the density ...
-
(HEFAT, 2016)The addition of drag-reducing agents to reduce spiral pipe friction loss has attracted attention as a method to conserve energy. In addition to reducing drag, these agents are required to have a low environmental load and ...
-
(HEFAT, 2016)Diesel particulate filters (DPF) are a widely used after-treatment method adopted in current diesel engines and the Gasoline Particulate Filter (GPF) is in the pipeline for future gasoline direct injection. The DPF accumulates ...
-
(HEFAT, 2016)The present work focuses on laminar dispersion of solutes in finite-length patterned microtubes. Dispersion is strongly influenced by axial flow variations caused by patterns of periodic pillars and gaps in the flow ...
-
(HEFAT, 2016)Direct numerical simulations (DNS) of flow past a stationary square cylinder with yaw angles of 0°~45° are performed at Reynolds number of 1000. The three-dimensional Navier-Stokes equations are solved using the finite ...
-
Development of a modal sub-structuring method : application to thermal simulations of LNG carriers (HEFAT, 2016)In the context of simulations of coupled thermal enclosures, we present here a sub-structuring technique adapted to a reduced modal formulation. This technique consists in splitting the geometry into different zones. A ...
-
(HEFAT, 2016)This paper reports an experimental investi- gation on the response of a turbulent wake past an elongated flat plate to various upstream flow conditions. Different tripping wires were placed on the upper side of the ...
Now showing items 21-40 of 293